Control panel buttons
Power
Press and release the Power button to turn the robot ON of OFF. The robot will begin a clean cycle when power is turned on.
Press and hold, while at the home position, to enter night light setting mode.
Cycle
Press and release the Cycle button to start a clean cycle.
If already cycling, press Cycle to pause; press again to resume a cycle.
Press and hold, while at the home position, to enter sleep mode.
Empty
Press and release the Empty button to start an empty cycle (empties all litter into the waste drawer). If you use the Whisker app, press Reset Gauge in the Controls section of the app when you empty the waste drawer to reset the waste drawer level in the app.
If already cycling, press Empty to pause; press again to cancel a cycle.
Press and hold, while at the home position, to enter cycle delay setting mode.
Reset
Press and release the Reset button to reset the cat sensor. (Do this after emptying the waste drawer, adding litter, etc.)
If already cycling, press Reset to pause; press again to cancel a cycle.
Press and hold, while at the home position, to enter control panel lockout.
What do the lights mean?
Yellow & red flashing sequentially:
Motor detects obstruction or jam during clockwise rotation. Learn more.
Blue & red flashing sequentially:
Motor detects obstruction or jam during counter-clockwise rotation. Learn more.
Blue, yellow, red flashing sequentially:
Cannot find Dump position. Learn more.
Red, yellow, blue flashing sequentially:
Cannot find Home position. Learn more.
Red, yellow, blue flashing simultaneously:
Cannot find Dump or Home position.Learn more.
Need technical support?
Our Troubleshooting Wizard will solve most issues and is the fastest way to get help.
